PSAapplication1
RubberMill pressure sensitive adhesive systems are designed to meet most industrial requirements. Acrylic and rubber based PSA transfer systems can be applied to most rubber, sponge and fiber materials. Roll goods up to 60″ wide can be laminated to one or two sides to create layered composites.

Rubber base PSA characteristics Acrylic base PSA characteristics
  • Medium service temperature (up to 200°F)
  • Poor UV resistance
  • Good initial tack and adhesion
  • Adheres to wide variety of substrates
  • Poor resistance to plasticizers and solvents
  • Cost effective

Rubber Base Adhesive Spec Sheet

  • High service temperature (up to 300°F)
  • Excellent UV resistance
  • Poor to medium initial tack
  • Excellent resistance to plasticizers and solvents
  • Good aging performance
  • Medium cost

Acrylic Base Adhesive Spec Sheet

Important Tips for Use of Parts with Pressure Sensitive Adhesive (PSA)

Storage: Enclosed parts should be stored in a cool, dry area (64°F-76°F), and 50-70% humidity. The supplier is not responsible for the performance of parts that have been stored improperly or for parts that have been stored for longer than six (6) months.

Surface Preparation: Surface must be free from oil, grease, cutting fluids, dirt, dust and moisture. Cleaning agents should be used that do not leave a residue. Different surfaces will result in different bond strengths.

Application: Make sure that both parts are at room temperature (72°F) or above before application. Both parts should be at the same temperature. Part should be applied firmly and uniformly. Stretching the part during application will result in release from the surface.